Skip to content
Haul Handbook logoHaul Handbook

Washington trucking

Washington CDL requirements and cost

Washington State Department of Licensing issues Washington CDLs. The fees on this page come from the agency's own published schedule, the skills test runs through agency offices or approved third-party testers, and the federal entry-level driver training rule applies before you can test. Every figure below carries the official source it came from.

By Evan Reid, Founder of Haul Handbook · Updated Aug 9, 2026

Quick answers for Washington CDL applicants

Use this page to answer the three searches most CDL applicants make before choosing a school or booking a test: what the state charges, where the skills test is handled, and whether the state adds anything beyond federal ELDT.

Published fee lines
7

Amounts below come from Washington State Department of Licensing.

Skills testing
agency offices or approved third-party testers

Use the agency testing notes below.

Training rule
Federal ELDT applies

State-specific ELDT notes are cited below.

What a Washington CDL costs

These are the license-side fees Washington State Department of Licensing publishes; training tuition is a separate, school-set cost covered in our CDL training cost guide. A line reading "Not confirmed" means the agency publishes no figure; the note beside it says what the agency does say.

Commercial learner's permit (CLP)
$40 (180 days from the date issued, renewable once for another 180 days when the renewal is made within 30 days of the expiration date)A driver issued an original CLP waits 14 days before taking a skills test. The permit may be renewed one time only.
Add a CDL endorsement to a Washington driver license
No single amount applies. The Department of Licensing prices this line as a $20 license fee plus $17 for each year remaining on the driver license, and publishes the total as a range of $37 to $156. What a given applicant pays depends on how much of their driver license term is left, so no fixed figure is recorded.Term: The time left to run on the underlying Washington driver license
Renew a Washington driver license carrying a CDL endorsement
The department publishes two amounts rather than one: $163 for six years or $217 for eight years with a CDL endorsement, and $193 for six years or $257 for eight years when the license carries both CDL and motorcycle endorsements. A renewal made more than 60 days after the license expires adds $10.Term: 6 years or 8 years, at the driver's choice

Endorsement fees

Endorsements ride on the base license; hazmat also carries a federal background check handled outside the license fee. Our hazmat endorsement guide covers that federal layer.

Washington CDL endorsement fees
EndorsementFeeNotes
Add a CDL special endorsement to a Washington driver license$20One published line covers the special endorsements; the fee table points at the department's endorsements and restrictions page for which endorsements it reaches.

Scroll sideways to see every column.

Test fees

Washington CDL test fees
TestFeeNotes
CDL knowledge test$35
CDL skills test, truck or passenger$175The fee buys two attempts. Changing examiners after a first attempt can mean paying the fee again. The department lists the same amount for a Head Start skills test.
CDL skills test for a school bus endorsement$100Open to an applicant whose main use of the CDL is driving a school bus. The fee buys two attempts.

Scroll sideways to see every column.

Other published fee lines

Other Washington CDL fee lines
ItemFeeTermNotes
Transfer an out-of-state CDL to a Washington CDLNot confirmed6 years or 8 yearsPublished as $213 for six years or $267 for eight, built from a $50 application fee, a $27 per year issuance fee and a $1 technology fee. The department warns the total varies with the license expiration day, so no fixed figure is recorded.
CDL requalification after a disqualification$35
Late renewal charge$10Added when the renewal is made more than 60 days after the license expires.

Scroll sideways to see every column.

The fee table itemises the knowledge test, the skills test, the learner permit and the requalification, and folds the licence itself into a driver license transaction priced by remaining term. It carries one $20 line for adding a CDL special endorsement rather than separate amounts for the hazardous materials, tank, passenger, school bus or doubles and triples endorsements, and it publishes no CDL replacement or duplicate line, so none is recorded here. Third party examiners set their own charges on top of the department's test fees.

Who gives the skills test in Washington

States split between running CDL skills tests themselves and certifying third-party testers; it changes where you book and who you pay.

Testing model
Washington runs both channels and says so directly: an applicant tests with a department examiner or with a third party examiner, and the department certifies the third party examiners itself and publishes a list of them. Knowledge testing is booked by appointment at a driver licensing office that offers it. A skills test with a department examiner is scheduled on 360-902-3785; a third party examiner is booked with that examiner, at least three days before the test date. Washington has moved to the AAMVA modernised skills test, and the department publishes a supplement to the commercial driver guide covering the segments that changed.
Scheduling
The department publishes an appointment tool for knowledge and skills testing and a separate finder for independent third party examiners on its CDL training and testing page. No single booking address covers both channels, so none is recorded.
Before you apply
An applicant holds a valid Washington driver license before applying, is at least 18 for commercial driving inside Washington and at least 21 to run across state lines, self-certifies the type of driving they will do, and carries a current medical certificate posted to the National Registry. The department's published sequence runs knowledge test, commercial learner permit, Washington training, skills test, then a licensing office appointment for issuance.

Every applicant also needs a current medical certificate; our DOT physical guide covers the exam that produces it. Not sure your truck even needs a CDL? Start with CDL vs non-CDL.

The federal training rule, then Washington's position

Entry-level driver training (ELDT) is federal: it applies in every state before the tests it gates, and the training must come from a provider on FMCSA's registry. The full walkthrough lives in our how to get a CDL guide.

Who must train
First-time Class A or Class B applicants; Class B holders upgrading to Class A; First-time S, P, or H endorsement applicants
Registry requirement
Entry-level driver training means training received from an entity listed on FMCSA's Training Provider Registry, completed before taking the CDL skills test for a first or upgraded Class A or Class B CDL, before the skills test for a first P or S endorsement, or before the knowledge test for a first H endorsement. You must complete training with a provider listed on the registry.
States may add more
States with training requirements that exceed the federal minimum standard may prohibit you from taking the skills test, or the knowledge test for the H endorsement, until you meet their state requirements as well as the federal ones. Federal rules also allow you to receive training and take the CDL skills test in a state other than the state you are licensed in.

Washington stacks its own minimum training hours on top of the federal entry level driver training rule, and a carrier hiring in this state should plan around the longer course. WAC 308-100-033 sets 160 hours for a Class A CDL, made up of 40 classroom hours, 18 hours of street driving, 16 hours of backing, 16 hours of proficiency development and 70 combined lab, range and observation hours. Class B and Class C run 80 hours on the same pattern, and passenger, school bus and hazardous materials endorsement courses carry their own hour counts. Every classroom course includes at least a 30 minute Truckers Against Trafficking section, and a student completes all portions within one year of starting. The provider must be approved by the department and listed on the FMCSA Training Provider Registry. WAC 308-100-035 lets an employer certify training it gives its own employees to the same standard, and the department must receive electronic notice of a successful completion before that employee takes a skills test.

The official manual and where this fits

The knowledge tests come straight from the state's own manual, so study the agency's current edition: Washington State Commercial Driver Guide. The CDL licenses you as a driver; if the plan is your own trucks and your own freight, the business side runs on its own track through start a trucking company in Washington.

If you searched for Washington CDL requirements, go here next

Still deciding if you need a CDL?

Start with the vehicle weight and use case. The national guide explains the CDL threshold before you pay for a permit or training.

Compare CDL vs non-CDL

Ready to drive under your own authority?

The CDL is the driver credential. Operating authority, IRP, IFTA, insurance, and permits are the business credential stack.

See the Washington startup sequence

Frequently asked questions

Who gives the CDL skills test in Washington?

Washington runs both channels and says so directly: an applicant tests with a department examiner or with a third party examiner, and the department certifies the third party examiners itself and publishes a list of them. Knowledge testing is booked by appointment at a driver licensing office that offers it. A skills test with a department examiner is scheduled on 360-902-3785; a third party examiner is booked with that examiner, at least three days before the test date. Washington has moved to the AAMVA modernised skills test, and the department publishes a supplement to the commercial driver guide covering the segments that changed.

Does Washington require training beyond the federal ELDT rule?

Washington stacks its own minimum training hours on top of the federal entry level driver training rule, and a carrier hiring in this state should plan around the longer course. WAC 308-100-033 sets 160 hours for a Class A CDL, made up of 40 classroom hours, 18 hours of street driving, 16 hours of backing, 16 hours of proficiency development and 70 combined lab, range and observation hours. Class B and Class C run 80 hours on the same pattern, and passenger, school bus and hazardous materials endorsement courses carry their own hour counts. Every classroom course includes at least a 30 minute Truckers Against Trafficking section, and a student completes all portions within one year of starting. The provider must be approved by the department and listed on the FMCSA Training Provider Registry. WAC 308-100-035 lets an employer certify training it gives its own employees to the same standard, and the department must receive electronic notice of a successful completion before that employee takes a skills test.

Where do the Washington CDL fees on this page come from?

Every dollar amount renders from Washington State Department of Licensing's own published fee schedule, cited beside the figure. When the agency publishes no figure for a line, this page shows the agency's own note instead of a guess.

Do I need my CDL before starting a trucking company?

They are separate tracks: the CDL licenses the driver, while operating authority licenses the business. Most owner-operators finish the CDL first because revenue depends on it, then file the business-side registrations. The state startup guide linked on this page covers that second track in order.

Haul Handbook publishes educational information about trucking registration and compliance requirements. This is not legal, financial, or tax advice. Rules, fees, and deadlines change; confirm with the agency before you file or pay.